Installation Instructions
Fixing Down the Rail
Step 1
Run the stairlift down to the bottom of the staircase
Step 2
Visually check that the rail is parallel to the adjacent wall, and looking up the stairs, behind the seat that the stairlift will not catch the wall on the way up.
Step 3
Also check that there are no obstructions such as window sills.
There should be approximately 25mm between seat back and the wall to avoid trapping hazards.
Step 4
Adjust the clearance between the stairlift and the wall by moving the rail in or out appropriately.
Step 5
Once checked and final position verified, screw the rail brackets down to the stairs using the screws provided (four per bracket).
Connecting the Transformer
DO NOT plug the transformer into the mains socket YET!
The transformer from the fitting kit now needs to be connected to the charge system wiring as follows:
Step 1
Insert the transformer lead through the hole on the underside of the rail (rubber-grommit) and out through the end of the rail.
Insert the transformer lead through the hole on the underside of the rail (rubber-grommit) and out through the end of the rail.
Step 2
Pull out the charge point wires and connector block from the end of the Rail and join the wires from the transformer into the connector block. The transfomer output is AC, either wire can be connected to either terminal.
Pull out the charge point wires and connector block from the end of the Rail and join the wires from the transformer into the connector block. The transfomer output is AC, either wire can be connected to either terminal.
Step 3
Push the jointed wires and connector block back into the rail end, push the rail end cap from the fitting kit over the end of the rail.
Ensure that the transformer wire is neatly routed so it will not cause a tripping hazard or get caught by the moving stairlift.
Push the jointed wires and connector block back into the rail end, push the rail end cap from the fitting kit over the end of the rail.
Ensure that the transformer wire is neatly routed so it will not cause a tripping hazard or get caught by the moving stairlift.
Plug in the transformer only on completion.