Installation Instructions
Check Joystick Controls
Step 1
Press the toggle switch in the 'UP' direction. The stairlift should start to travel upwards.
Step 2
Press the toggle in the 'DOWN' direction. The stairlift should start to travel down.
Check Remote Controls
Step 1
Pressing the red button causes the lift to ascend after a short delay.
By releasing the button the stair lift will stop travelling.
Step 2
Pressing the green button causes the lift to descend after a short delay.
By releasing the button the stair lift will stop travelling.
Check Safety Sensors
Step 1
Footrest ‘top’ side sensor - with the lift ascending, push top-side spring-loaded edge of footrest - lift should stop immediately.
LED Display will show '8'.
Step 2
Footrest ‘bottom’ side sensor - with the lift descending, push bottom-side spring-loaded edge of footrest - lift should stop immediately.
LED Display will show '7'.
Step 3
Footrest base sensor - with the lift descending, push the base of the footrest upwards - lift should stop immediately.
LED Display will show '7'.
Step 4
Carriage ‘top’ side sensor - with the lift ascending, push the top-side spring-loaded moulding attached to the carriage, immediately surrounding the rail - lift should stop immediately.
LED Display will show '9'.
Step 5
Carriage ‘bottom’ side sensor - with the lift descending, push the bottom-side spring-loaded moulding attached to the carriage immediately above the rail - lift should stop immediately.
LED Display will show 'A'.
Check stopping limits
Step 1
Bottom stopping limit operative - run the lift right to the bottom of the rail - lift should automatically come to a ’soft’ stop at the foot of the staircase.
Step 2
Top stopping limit operative - run the lift right to the top of the rail - lift should automatically come to a ’soft’ stop at the top of the staircase.
Check Seat Swivel
Turn the seat toward the top of the stairs away from the riding position.
The LED display should show '4' and the stairlift will not operate.
Check Battery Isolation Switch
Turn the battery isolation switch to the 'OFF' position, or remove red isolation plug (dependant on model).
The LED display should go blank and the stairlift will not operate.
Check Key Switch
Turn the key switch to the 'OFF' position.
The LED display should change to '5' and the stairlift will not operate.
Check Fixing of Carriage to Rail
Ride the stairlift up and down once, ensuring the ride is smooth and stable and that the stairlift stops in the correct positions at top and bottom.